Differences

This shows you the differences between two versions of the page.

--- hardware:room-case-2.0 [2025/09/21 13:38] – andi
+++ hardware:room-case-2.0 [2025/10/11 22:16] (current) – add tipps and ticks section jtbx
@@ Line 96: / Line 96: @@
 <WRAP clear></WRAP>
+===== Tipps and Tricks =====
+<bootnote>
+\\
+Modules are singular units. Do not disassemble them!\\
+The cases have additional adapters for your needs like a second UpDownCross. Never take components from a module to use them somewhere else!
+</bootnote>
+==== Select Audio Input of ATEM Mini ====
+Laptop audio can be passed to the audio mixer in two ways: Via HDMI or via 3.5mm jack.
+Please check on the ATEM mini which input is selected!
+{{ :hardware:lectern-audio-comp.jpeg |}}
+==== Extend Lectern Module Tray ====
+The lectern module's tray has some cable ties to stop being fully extended.
+If the tray is pulled out too much, the cables to the I/O panel will probably get dislodged and will cram up between rack tray and network switch!
+So **do not pull out the tray more than needed**!
+In case you need to reach the additional ports (HDMI and secondary SDI) of the UpDownCross, you can get over the stoppers with these steps: {{ :hardware:lectern-tray-stoppers_hands-comp.jpeg?600|}}
+  * Pull tray out until stoppers are reached
+  * Place your hands with 4 fingers below the tray and the thumb on top
+  * Press up next to the cable tie stopper until it goes past the I/O panel below
+{{ :hardware:lectern-tray-stoppers-comp.jpeg?600|}}
+<WRAP clear></WRAP>
 ===== Assembly =====