Differences

This shows you the differences between two versions of the page.

--- hardware:viri-esp [2026/04/13 20:25] – created commanderred
+++ hardware:viri-esp [2026/04/13 20:37] (current) – commanderred
@@ Line 1: / Line 1: @@
 = Viri ESP
-Viri-ESP is a ESP-32 based hardware project for making our alert system inside the VOC office easy to deploy when the voc2dmx hardware is not around.
+Viri-ESP is a ESP-32 based hardware project for making our alert system inside the VOC office easy to deploy when the voc2dmx hardware is not around. It should be found in the R2 box.
 The source code for the ESP-IDF based version (the newer one) can be found [[https://forgejo.c3voc.de/voc/viri-leds-idf|on our git forge]].
@@ Line 21: / Line 21: @@
 == Web-UI
+For basic operation, a webui is hosted both on the AP and STA interface.
+Directly next to the page title, you can find a reboot button and a "Toggle viri handling" button. The latter is used to disable processing of the MQTT messages on `/voc/alert-viri` in case of excessive blinking. This is reverted by clicking the button again or rebooting the ESP-32.
+Below that is a box with status information about the ESP-32. It shows uptime, the git-hash the of the flashed firmware and connectivity information.
+After that there is a quick config section. Here you can change the brightness of the ledstrip, configure its length or change the wifi credentials.
+While not required for basic operation, below that is a config explorer for all the config keys exposed by the firmware.
+{{.:pasted:20260413-202826.png?1300|Screenshot of the webui}}
+== Pictures
+{{.:pasted:20260413-203623.png?400|Picture of the ESP-32 board}}